Communicator Installation Configuration; Installing Ethernet Communicator In Panel - DSC TL280R Installation Manuals

Communicator Installation Configuration

C
OMMUNICATOR
This Ethernet Communicator shall be installed by service persons only (service person is defined
as a person having the appropriate technical training and experience necessary to be aware of haz-
ards to which that person may be exposed to in performing a task and can also take measures to
minimize the risks to that person or other persons). The Communicator shall be installed and used
within an environment that provides the pollution degree max 2, overvoltages category II, in non-
hazardous, indoor locations only. This manual shall be used with the installation manual of the
panel which is connected to the Ethernet communicator. All instructions specified within the panel
manual must be observed.
All the local rules imposed by local electrical codes shall be observed and respected during instal-
lation.
I
NSTALLING
Installing Communicator with HS2016, HS2032, HS2064, and
HS2128 Panel
1. To assemble supplied mounting bracket, perform the following: (see Figure 1).
a. Remove the 4 white plastic standoffs
from the bag provided with the com-
municator kit.
b. Insert the 4 standoffs through the back
of the mounting bracket, into the holes
at each corner.
c. Place the bracket on a flat, solid sur-
face. Hold the communicator compo-
nent side up and orient the 4 holes on
the communicator with the 4 standoffs
protruding from the bracket. Push the
communicator firmly and evenly onto
the standoffs until it is securely
attached to the mounting bracket.
d. Remove the panel front cover.
e. Remove and discard the circular knockout located
in the top-right section of the panel.
2. Install the Communicator into the panel:
a. Attach one end of the PC-LINK cable to the panel
PC-LINK header on the panel (red wire goes on
the right-hand pin of the panel PCLINK_2 header
(see Figure 3)).
b. Insert the assembled communicator into the panel.
c. Locate the screw hole on the right side wall of the
panel (see Figure 2 (screw)). Line up the assem-
bled communicator with the right side wall of the
panel and, using the screw provided, secure the
mounting bracket to the panel.
d. Attach the other end of the PC-LINK cable to the
communicator (red wire goes on the right-hand pin
of the communicator PC-LINK header (see Fig-
ure 3)).
e. Using light pressure (finger tight only), attach the supplied white quad band whip antenna to
the threaded antenna connection point at top of the panel.
WARNING! - Modules are power limited. Do not route any wiring over the circuit board.
Maintain at least 1in. (25.4mm) separation between circuit board and wiring. A minimum
of ¼ in. (7mm) separation must be maintained at all points between non-power limited
wiring and power limited wiring.
3. To electrically connect the communicator to the panel, perform the following steps (see Figure 3).
I
NSTALLATION
E C
THERNET
Mounting Holes
Communicator
Board
Internet Alarm Communicator Installation Guide
C
ONFIGURATION
OMMUNICATOR IN
Figure 1:Communicator Mounting Bracket
Stand Off
Mounting
Plate
Figure 2:HS2016/2032/2064/2128 Control Panel
cable connector
HS2016/2032/2064/2128
3
P
ANEL
Mounting
Holes
Mounting Plate
PC-Link
GSM Radio
RJ-45
screw