Troubleshooting - Screen Innovations Solo Installation Instructions Manual

TROUBLESHOOTING

All Solo and Solo Pro screens are programmed and
tested at the factory. All battery powered models are
shipped in 'sleep mode' to preserve battery life and to
keep the motor from being inadvertently operated by
stray RF signals during transport or storage. In case of
a malfunction please use the following troubleshooting
guide table.
Symptom Possible Cause
Non- Motor is asleep
responsive
remote
Remote orientation
RF interference
Motor battery fully
discharged
Troubleshooting
Solution
Plug the charger and
connect cable
Hold remote vertical
Turn off other sources
of RF
Charge for 6 hours
min.
23
Tech Support: 512.832.6939
Symptom Possible Cause
Non- RF Shielding
responsive
remote
(-cont.)
Remote battery is
dead
Vertical Material has
wrinkles in shifted at the
screen weight bar
When down An intermediate
button is
stop was set for
pressed,
the motor
screen
stops
halfway
Troubleshooting
Solution
Move to position
where metal objects,
wiring, or foliage does
not block the signal.
Replace with CR2430
3V lithium button
battery
Gently move the
material out to each
end of the weight bar
until smooth.
Call SI Customer
Support to fix
24