Screen Innovations Solo Installation Instructions Manual page 13

To charge, plug in the wall charger into a 120V outlet,
then connect the magnetic end of the cable to the
charging port on the cassette. The light on the charger
will change from green to red as soon as the magnetic
end is connected, indicating that the batteries are
charging. Charge for at least 6 hours. When they are
fully charged, the charger indicator light will change
from red to green. Remove and store the cable and
charger and the screen is now ready to use. The
batteries can be charged and discharged over 500
times before end of life. With a 1 year typical use
period between charges, the batteries will last the life
of the product.
NOTE: As the temperature of the batteries drops, the
battery voltage also drops. If the Solo temperature
gets close to freezing, the motor may start flashing
red, indicating that it thinks it should be charged.
Simply bring the screen and batteries up to room
temperature. The motor light will stop flashing red.
Care and Maintenance
Although the cassette is protective, it should be
handled with care. Inadvertent small scratches, dents
or dings may be unsightly, but they will not affect
the operation of the screen. Wipe any smudges or
handprints off with a damp cloth. Dry thoroughly
after wiping.
21 Care and Maintenance 22