Table of Contents
Advertisement
Erase all RF Remote Fobs from the PIR
Light Controller
• Press and hold the centre button, located on the
bottom of the PIR light controller, for approximately
5 seconds. The lamp will flash 5 times. This
indicates that un-pairing has been successful.
Installing a RF Remote Fob into a Wall Switch
• Remove the rubber caps from
the bottom of the fob as shown.
15
• Using 2 of the wires supplied,
push them firmly into the 2 spring
clamp terminals. Check they are
both secure with a light tug.
Remove
rubber caps
Advertisement
Table of Contents
Need help?
Do you have a question about the LEDPRORFKB and is the answer not in the manual?
Questions and answers