Timeguard LEDPRORFKB Installation & Operating Instructions Manual page 14

Pairing the RF Remote Fob(s) with the PIR
Light Controller
Note: You must complete the Walk Test Procedure
before you can pair the devices. The pairing of the
fob(s) cannot be actioned with the PIR light controller
set to Test Mode. Make sure the PIR light controller is
functioning correctly and set for Automatic Operation
(Auto Mode) before you continue.
• Press the centre button that
is located on the bottom
of the PIR light controller once
13
(do not press and hold for
longer than 4 seconds), the
lamp will flash twice to indicate
it is ready to pair your fob(s).
Note: once the lamp has flashed twice, the PIR
sensor will no longer trigger the lamp with motion
until the pairing sequence has been completed.
• Press the fob button once.
The lamp will turn ON
for 3 seconds, and back
OFF again, to indicate
it has been registered.