Advertisement
MAINTENANCE
INSTALL NEW BATTERY; Fig. 13
A
1. Remove the six COVER PLATE SCREWS (1), then
remove COVER PLATE (2). Fig. 13.
2. Remove old BATTERY (3). Install the new BATTERY
(4), making sure the terminal side is inserted first and
shape of the battery follows the shape of the BATTERY
HOLDER (5). Reinstall COVER PLATE (2). Fig. 13a.
B
ADJUST STOP VALVE; Fig. 14
IMPORTANT: To avoid overflowing, the STOP VALVE (3)
must never be opened to the point where the flow from
the valve exceeds the flow capacity of the fixture. Valve
is designed to provide stated flush volume with a 10
GPM flow rate.
1. After installation is complete, remove COVER PLATE
(1). Peel off the PROTECTIVE FILM (2) from the sensor.
Standing to one side, block the sensor with your hand for
10 seconds. Remove your hand and listen for audible
"click" from within the valve.
2. Turn on STOP VALVE (3) 1/4 turn to 1/2 turn (CCW)
and test for leaks.
Note: Unit may flush for approximately 5 to 10 seconds
when water is first turned on. If flow persists, turn water
off and repeat step #1 above.
3. Actuate the FLUSH VALVE:
A) Cover sensor with hand for 10 seconds.
NOTE: Stand outside of sensor detection area.
B) Remove hand from detection area; unit will flush in
approximately 3 seconds.
4. Adjust STOP VALVE (3) after each flush until the stated
flush volume is achieved, no splashing occurs and the
fixture is properly cleansed.
5. Attach the COVER PLATE (1) to the WALL BOX (4) with
the six MOUNTING SCREWS (5). Use a 2.5mm Hex
Wrench supplied to secure COVER PLATE (1).
CARE INSTRUCTIONS:
DO: CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
Fig. 13
1
2
Fig. 13a
5
TERMINAL SIDE
3
Fig. 14
4
1
11
- P 2
C R
4
COUNTER-CLOCKWISE
OPENS STOP VALVE
2
5
M965643 Rev. 1.6 (11/16)
2
CLOCKWISE
CLOSES
STOP
VALVE
3
Advertisement
