Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. All American Standard Products Are Water Tested At Our Factory. UNPACKING Some Residual Water May Remain In The Valve During Shipping.
GENERAL DESCRIPTION: Fig. 1 SELECTRONIC™ PROXIMITY URINAL FLUSH VALVE Roughing-in Dimensions Fig. 1 Exposed Flushometer for 3/4" Top Spud Fixtures Right or Left Hand Installation See (Section 5) for converting Flush FINISHED WALL Valve to Left Hand Installation. 73 mm (2-7/8") 15˚...
Page 4
Fig. 3 FLUSH VALVE INSTALLATION FINISHED WALL CENTER LINE OF FIXTURE SPUD INSTALL SWEAT ADAPTER; Fig. 3 Turn water supplies off before CAUTION beginning (A-B)= Note: Install Optional Sweat Adapter (Supplied) for 32mm copper pipe supply line. (1-1/4") FILE EDGES 1.
Page 5
FLUSH OUT SUPPLY LINES; Fig. 6 Fig. 6 1. Remove STOP VALVE COVER (1) from STOP VALVE (2). REMOVE COVER 2. Open STOP VALVE (2) with a flat blade screwdriver. 3. Turn on water supply to flush line of any debris or sediment. 4.
If these items do need replacement they must be purchased separately or order the complete flush valve assembly from American Standard. 1. Remove STOP VALVE COVER (1) from STOP VALVE (2). 2. Turn water supply off.
Page 7
Fig. 11a STANDARD BATTERY REPLACE PWRX; Fig. 11, 11a Fig. 11 1. Loosen SET SCREW (1) with 2.5mm Hex Wrench (2) in REMOVE OLD INSTALL BATTERY back of FLUSH VALVE COVER (3). Fig. 11. BATTERY 2. Rotate COVER (3) to the right and pull off. Fig. 11. - P 2 3.
Page 8
SET DETECTION RANGE Fig. 13 (If Required); Fig. 13 & 14 Note: The detection distance is preset and ideal for most installations. Should an adjustment be required, follow the steps below. 1. Loosen SET SCREW (1) with 2.5mm Hex Wrench (2) in VIEW “A”...
Need help?
Do you have a question about the Ultima Selectronic 6064.013 and is the answer not in the manual?
Questions and answers