Computer Adjustment (Manual) - Sanyo PLV-Z1BL Owner's Manual

Sanyo multimedia projector model plv-z1, plv-z1bl owner's manual

Brochure & specs (3 pages)

Service manual (17 pages)

Table of Contents

This projector can automatically tune to the display signals from most personal computers currently distributed. However,

some computers employ special signal formats which are different from the standard ones and may not be tuned by Multi-

Scan system of this projector. If this happens, the projector cannot reproduce a proper image and the image may be

recognized as a flickering picture, a non-synchronized picture, a non-centered picture, or a skewed picture.

This projector has a manual computer adjustment to enable you to precisely adjust several parameters to match with those

special signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted.

This enables you to recall the setting for a specific computer whenever you use it.

Press the MENU button, and the main menu appears. Select

the Computer Adjustment menu with the POINT UP/DOWN

button, and then press the POINT RIGHT button to enter the

sub-menu.

Choose the item that you want to adjust, and then press the

POINT LEFT/RIGHT button to adjust the value. The Fine sync

and Total dots are displayed in a line. Press the SELECT button

after adjusting them. The on-screen menu returns to the sub-

menu.

To store the adjustment parameters, select the Store with the

POINT UP/DOWN button and press the POINT RIGHT button.

Reset

To reset to previous level, select the Reset with the POINT

UP/DOWN button and press the POINT RIGHT button. Select

"Yes" with the SELECT button.