National Instruments MXI-2 Reference Manual page 95

Note If you must remove the PCI-MXI-2, PCI-MXI-2 Universal, or PXI-8320 module
to access switch 1, follow the installation instructions in Chapter 2,
Configuration and
and Installation, or Chapter 4,
PCI-MXI-2, PCI-MXI-2 Universal, or PXI-8320 modules, respectively.
© National Instruments Corporation
Figure B-3. Restoring the Factory Configuration on the PCI-MXI-2
Figure B-4. Restoring the Factory Configuration on the PXI-8320
Installation, Chapter 3,
PXI-8320 Configuration and
4. Replace the PCI-MXI-2, PCI-MXI-2 Universal, or PXI-8320.
5. Power on the PCI-based computer or PXI/CompactPCI chassis.
The computer should boot this time, because the factory-default
configuration is being used to initialize the module.
6. Run the configuration utility that came with your National Instruments
software to re-adjust the PCI-MXI-2, PCI-MXI-2 Universal, or
PXI-8320 configuration.
7. After saving the configuration, shut down the operating system and
turn off the computer or chassis.
8. Remove the PCI-MXI-2, PCI-MXI-2 Universal, or PXI-8320.
9. Change switch 1 (FOV) to the OFF position.
10. Replace the PCI-MXI-2, PCI-MXI-2 Universal, or PXI-8320.
11. Power on the computer or chassis. If it does not boot with this
configuration, repeat these steps, modifying your configuration until
the computer or chassis boots successfully.
Appendix B
U17 or SW1
FOV
TST
POS
CT
or PCI-MXI-2 Universal
FOV
TST
POS
CT
PCI-MXI-2 Universal Configuration
B-3 MXI-2 Configuration Reference Manual
EEPROM Configuration
PCI-MXI-2
Installation, to reinstall the