Vxi-Mxi-2/B Configuration And Installation; Configure The Vxi-Mxi-2/B - National Instruments MXI-2 Reference Manual

VXI-MXI-2/B Configuration
and Installation
Caution Electrostatic discharge can damage several components on your VXI-MXI-2/B
module. To avoid such damage in handling the module, touch the antistatic plastic package
to a metal part of your VXI chassis before removing the VXI-MXI-2/B from the package.

Configure the VXI-MXI-2/B

© National Instruments Corporation
This chapter contains the instructions to configure and install the
VXI-MXI-2/B module. This chapter applies only if your kit contains a
B-size VXI-MXI-2. If you have a C-size VXI-MXI-2, refer to Chapter 5,
VXI-MXI-2 Configuration and
refer to Chapter 7, VME-MXI-2 Configuration and
Configuring the VXI-MXI-2/B is optional. A typical configuration can use
the default settings.
This section describes how to configure the following options on the
VXI-MXI-2/B:
• VXIbus logical address
• VXIbus Slot 0/Non-Slot 0
• VXIbus CLK10 routing
• Trigger input termination
• MXIbus termination
• Configuration EEPROM
• Onboard DRAM
• VXIbus local bus
Installation. If you have a VME-MXI-2,
6-1 MXI-2 Configuration Reference Manual
6
Installation.