National Instruments MXI-2 Reference Manual page 61

Note After installing DRAM on the VXI-MXI-2/B, you need to enable the memory
through Measurement and Automation Explorer (MAX).
Bank 0
—
256 K × 32 or
256 K × 36
256 K × 32 or
256 K × 36
512 K × 32 or
512 K × 36
512 K × 32 or
512 K × 36
1 M × 32 or
1 M × 36
1 M × 32 or
1 M × 36
2 M × 32 or
2 M × 36
© National Instruments Corporation
Use switch S2 to select the size of each SIMM. If the SIMMs are 4 M × 32
or larger, set S2 to the OFF setting as shown in Figure 6-10a. For SIMMs
smaller than 4 M × 32, use the ON setting as shown in Figure 6-10b.
S2
a. 4 M × 32 and Larger
Refer to Table 6-1 for how to adjust the switch (ON or OFF) for all
supported DRAM configurations. Many of the DRAM options are
available from National Instruments.
Table 6-1. VXI-MXI-2/B DRAM Configurations
Bank 1 Total DRAM
—
—
256 K × 32 or
256 K × 36
—
512 K × 32 or
512 K × 36
—
1 M × 32 or
1 M × 36
—
Chapter 6 VXI-MXI-2/B Configuration and Installation
Figure 6-10. SIMM Size Configuration
National
Instruments
Option
0
1 MB
2 MB
2 MB
4 MB
4 MB
8 MB
8 MB
6-13
S2
b. Smaller than 4 M × 32
Switch Setting
of S6
—
— ON
— ON
— ON
— ON
YES ON
— ON
YES ON
MXI-2 Configuration Reference Manual
—