Table of Contents
Advertisement
VXI-MXI-2 Configuration
and Installation
Electrostatic discharge can damage several components on your VXI-MXI-2
Caution
module. To avoid such damage in handling the module, touch the antistatic plastic package
to a metal part of your VXI chassis before removing the VXI-MXI-2 from the package.
Configure the VXI-MXI-2
© National Instruments Corporation
This chapter contains the instructions to configure and install the
VXI-MXI-2 module. This chapter applies only if your kit contains a C-size
VXI-MXI-2. If you have a B-size VXI-MXI-2, refer to Chapter 6,
VXI-MXI-2/B Configuration and
skip this chapter and refer to Chapter 7,
and
Installation.
Configuring the VXI-MXI-2 is optional. A typical configuration can use
the default settings.
This section describes how to configure the following options on the
VXI-MXI-2:
•
VXIbus logical address
•
VXIbus Slot 0/Non-Slot 0
•
VXIbus CLK10 routing
•
Trigger input termination
•
MXIbus termination
•
Configuration EEPROM
•
Onboard DRAM
•
VXIbus local bus
Figure 5-1 shows the right-side cover of the VXI-MXI-2. The drawing
shows the location and factory-default settings of the configuration
switches and jumpers on the module. Notice that you can access switch S6
(called out as number 8 in the drawing) only by removing the front cover.
Installation. If you ordered the VME kit,
VME-MXI-2 Configuration
5-1
MXI-2 Configuration Reference Manual
5
Advertisement
Chapters
Table of Contents
