D-Link DWR-956 User Manual page 174

DWR-956 Wireless AC1200 4G LTE Router
with Gigabit Ethernet Ports and 1 FXS Port
User Manual
Parameter
Support SoftX3000
Port
Fax/Modem
determination
Enable custom
parameters
Maximal buffer
Rate management
Maximal rate
Error correction mode
Enable spoofing
Duplicate number
Enable V.152 support
Payload type
Codec type
When all needed settings are configured, click the APPLY button.
Move the switch to the right to let the router support operation with
SoftX3000. If the switch is moved to the right, the Port field is
unavailable for editing.
The router's port for data transfer via T.38.
From the drop-down list, select a mode of fax/modem signal
detection.
Move the switch to the right to specify additional parameters for
T.38. Upon that the Custom parameters T.38 section is displayed
on the page.
Custom parameters T.38
The maximum buffer size for data received by the router.
From the drop-down list, select a method for facsimile data transfer
rate management: Local or Remote.
From the drop-down list, select the maximum rate for facsimile data
receipt/transfer.
Move the switch to the right to enable the error correction mode.
When the switch is moved to the right, the ECC signal and ECC
data fields are available for editing.
Move the switch to the right to let the router simulate facsimile data
receipt/transfer in case of delays.
Specify number of packet duplications.
V.152
Move the switch to the right to allow support of the V.152
recommendation. Upon that the Payload type field and the
Codec type drop-down list are displayed on the page.
Payload data type in accordance with RFC2833.
From the drop-down list, select a codec for data transfer in
accordance with V.152.
Page 174 of 221
Configuring via Web-based Interface
Description