Related Manuals for D-Link DWR-926
Summary of Contents for D-Link DWR-926
- Page 1 Quick Installation Guide 4G LTE M2M VPN Router This document will guide you through the basic installation process for your new D-Link 4G LTE M2M VPN Router. DWR-926 Quick Installation Guide...
-
Page 2: Before You Begin
Before You Begin This Quick Installation Guide gives you step-by-step instructions for setting up your DWR-926 4G LTE VPN Router. The model you have purchased may appear slightly different from the one shown in the illustrations. For more detailed information about the router, please refer to the User Manual. -
Page 3: Hardware Overview
Green: Flash(Fast): Signal Strength is 0~30% LTE Mode Flash(Slow): Signal Strength is 31~60% Solid: Signal Stregth is 61~100% Cellular 1 Signal Amber: Flash(Fast): Signal Strength is 0~30% HSPA/3G Mode Flash(Slow): Signal Strength is 31~60% Solid: Signal Stregth is 61~100% DWR-926... -
Page 4: Rear Panel
Figure 2 Item Description 3G/4G MAIN SMA female connector - Primary Antenna for 3G/4G Wi-Fi Antenna 2 SMA male connector - Wi-Fi 2. Press and hold for 10 seconds to restore factory Reset defaults. 2x 4FF size nano-SIM slots. DWR-926... -
Page 5: Hardware Installation
Observe the following precautions to help prevent shutdowns, equipment failures, and personal injury: • Install the DWR-926 in a cool and dry place. Refer to the technical specifications in the user manual for the acceptable operating temperature and humidity ranges. -
Page 6: Attaching The External Antennas
Do not stack any devices on top of the router. Attaching the External Antennas Figure 3: Attaching External Antennas The DWR-926 requires four external antennas to function correctly: two blade antennas for 3G/4G, and two Wi-Fi antennas. The included antennas are interchangeable, but third party antennas may require connection to specific ports. -
Page 7: Installing A Sim Card
Installing a SIM card The DWR-926 is equipped with x2 4FF size nano-SIM slots. An active SIM card is required for 3G/4G access. 1. Unscrew the SIM slot cover on the front of the device. -
Page 8: Powering The Router
The router requires 12 volt power supply and a minimum of 2 amp. Using the Included AC Adapter 1. Attach the barrel connector of included AC adapter to the DWR-926 power port on the rear panel. 2. Attach the AC adapter to an appropriate AC socket. DWR-926... -
Page 9: Connecting Devices
Connecting Devices After the DWR-926 has been successfully installed, the router can be connected to the end device via the following connection methods: Over Ethernet The Ethernet port can be connected to an end device. Use a standard Category 5/5e/6 RJ-45 Ethernet cable to connect the end device to the router. -
Page 10: Management Options
The D-Link router can be managed by using either the Web User Interface (Web UI) or Telnet management interfaces. If you wish to manage a single D-Link router, the Web UI may be the best option. Each router must be assigned its own IP address, which is used for communication with the management PC. -
Page 11: Additional Information
Additional help is available through our offices listed at the back of the user manual or online. To find out more about D-Link products or marketing information, please visit the D-Link website at: http://www.dlink.com/. - Page 12 NOTES DWR-926...
- Page 13 NOTES DWR-926...
- Page 14 WIRELESS NETWORK REMINDER Wireless Network Name (SSID) Wireless Network Password Ver. 1.00(DI)_90x130 2019/11/14...