Camera Control Tool For Cv-40; Default Settings At Power Up - IAI CV-M40 Operating Manual

CV-M40

7.3. Camera Control Tool for CV-40

From www.jai.com Camera Control Tool for Windows 98/NT/2000 can be downloaded.
The control tool contents a camera control program and tools for making your own program.
For the integrator and experienced user, the Camera Control Toll is much more than a program
with a window interface. It also provides an easy and efficient ActiveX interface built for MS
Windows 98, ME, NT and 2000. The OCX interface has the ability to connect to the camera using
the serial interface of the PC by reading and writing properties for the camera. This integration
requires simple programming skills within Visual Basic, Visual C++ or similar languages in a
Microsoft Windows environment.
Below the different windows are shown.
Fig. 30. Camera control tool windows.

7.3.1. Default settings at power up

With the camera rear switch SW1-8 "CONTROL" in "RS 232C, the camera will start with the
settings stored in user settings. The user settings can only be stored via RS-232C.
If the camera rear switch SW1-8 "CONTROL" is in "Local", the camera will start with the settings
given by the switch and jumper setting.
- 21 -