5
Getting started
5.1
Power supply
5.1.1
Power on
When the device is in standby mode, hit the "Power"-key to start the instrument and enter the
main menu.
NOTE: The battery switch has to be set to "ON".
5.1.2
Power off
When the device is switched on, hit the "Power"-key to put the device into standby mode.
NOTE: If the instrument is not used for a longer period of time, please set the battery switch to
"OFF".
5.2
Preparation
-
Check the battery voltage
-
Clean the workpiece surface that needs to be tested
-
Connect the sensor to the host with reference to the graphic below
© PCE Instruments
7