Recovery; Initial Login - NetModule NB2800 User Manual

as one that contains numbers, letters and punctuation characters). The password shall have
a minimum length of 6 characters. It shall contain a minimum of 2 numbers and 2 letters.
Please note that the admin password will be also applied for the root user which can be
used to access the device via the serial console, telnet, SSH or to enter the bootloader. You
may also con gure additional users which will only be granted to access the summary page
or retrieve status information but not to set any con guration parameters.
A set of services (USB Autorun, CLI-PHP) are by default activated in factory state and will be
disabled as soon as the admin password has been set. They can be enabled again afterwards
in the relevant sections. Other services (SSH, Telnet, Console) can be accessed in factory
state by providing an empty or no password.

5.1.2. Recovery

Following actions might be taken in case the router has been miscon gured and cannot be
reached anymore:
1. Factory Reset: You can initiate a reset back to factory settings via the Web Manager,
by running the command factory-reset or by pressing the reset button. The latter
would require a slim needle or paper clip which must be inserted into the hole
the right of the SIM 4 slot
until all LEDs ash up.
2. Serial Console Login: It is also possible to log into the system via the serial port. This
NB2800 User Manual 4.2
Figure 5.1.: Initial Login
. The button must be hold pressed for up to 5 seconds
32
to