NetModule NB2800 User Manual page 162

General settings:
Parameter
Administrative status
The following parameters can be used to con gure a virtual guest:
Parameter
Type
Description
Storage
To Install a root- le-sytem you can set up a URL to load a the image from and trigger the
installation:
Parameter
URL
Install
Communication to and from the guest can be achieved by de ning network interfaces which
can be either routed towards the guest or bridged with a LAN interface:
Parameter
Guest interface
Mode
Address
Netmask
Gateway
NB2800 User Manual 4.2
Virtualization Settings
De nes whether virtualization is enabled or not
Guest Settings
De nes which virtualization technique is being used
The description of the guest
Speci es the storage device on which the root le system of
the guest will be located
Install
The URL to load the image from. The Image needs to be pro-
vided as XZ compressed TAR archive containing the les of a
root FS compatible with our CPU architecture (armv7l). Differ-
ent protocols may be used for the transaction like 'http://' or
'https://', 'ftp://' or 'tftp://'. If you uploaded the the image to
the router in advance you can also use ' le://' followed by the
local path of the le.
We can provide various tailored Linux distribution images
(such as Debian) on demand.
If this trigger is set the image download will start on apply.
Any existing root le system will be overwritten. This param-
eter will not be stored in the con guration. After the installa-
tion was proceeded the value will be reset and needs to be set
again if a new image shall be installed.
Guest Networking
The name of the interface inside the guest
The network mode for this interface (either routed or bridged)
The IP address of the interface inside the guest
The netmask of the interface inside the guest
The gateway used inside the guest which is also set on the host
interface
153