Entry Of Numerals, Letters And Characters - wtw photoLab 6100 VIS Operating Manual

®
photoLab 6100 VIS
Special characters
Operating example:
Entering the ID
Correcting incorrect
entries
ba75849e06 06/2013
4.2.3

Entry of numerals, letters and characters

Numerals, letters, punctuation marks and special characters are entered with
the alphanumeric keypad of the meter or using an external keyboard.
The numerals and characters (expect for the small letters) assigned to the
keys of the alphanumeric keypad are printed on the keys. Example: With the
<7/PQRS> key you can enter the following characters: 7, P, Q, R, S, p, q, r, s.
Select the required character by pressing the key several times (similar to a
mobile phone). When pressing a key that is assigned to several characters
once, the respective numeral appears first. To enter a numeral, one
keypressing is always sufficient.
When pressing the key for the first time a line pops up that displays all
characters possible with this key. The currently selected character is
highlighted.
A character is taken over in the input field if
 the character is highlighted for more than one second,
 the character is confirmed with <START·ENTER>,
 another alphanumeric key is pressed.
Special characters are entered with the <1/*> key.
The Enter ID input field appears if you press the <STORE> key while the
storing symbol is visible. In the following example a measurement dataset
with the ID "Test" is stored.
Enter ID
8
8 T U V t u v
Enter ID
T
8 T T U V t u v
Enter ID
Test_
Using <>, erase all characters until you have reached the incorrect digit and
repeat the entry from there.
1 Press <8/TUV> several times until
"T" appears in the input line.
Below the input field, a selection
line pops up with all characters
that are available for this key, e.g.
8 T U V t u v.
The currently selected character is
highlighted.
After approx. one second the
character is taken over and the
selection line closed.
2 Complete the ID with <A...9> and
confirm.
Operation
21