Initial Commissioning; Inserting The Buffer Batteries - wtw photoLab 6100 VIS Operating Manual

Commissioning
Packing
12
3.2

Initial commissioning

Perform the following activities:
 Insert the buffer batteries (see section 3.2.1)
 Connect the power supply (see section 3.2.2)
 Switch on the photometer (see section 3.2.3)
 Set the language (see section 3.2.3)
 Set the date and time (see section 3.2.4)
 Carry out zero adjustment (see section 4.3)
This photometer is sent out in a protective transport packing.
WARNING
Always keep the original packing including the inner packing. If you
have to transport the instrument, the packing protects the instrument
optimally from hard shocks.
The original packing is also required for the appropriate return
transport of the instrument if it has to be repaired.
Please note that the warranty does not cover damage caused by
inappropriate transport.
3.2.1

Inserting the buffer batteries

The buffer batteries supply the integrated clock while the photometer is
switched off. Four alkaline manganese batteries (type AA or Mignon)
separately included in the scope of delivery are used as the buffer batteries.
Insert the batteries as follows:
1
photoLab
1 Turn the photometer upside down
and place it on a soft surface.
2 Open the lid of the battery
compartment (1).
3 Insert the four batteries in the
battery compartment. Make sure
that the poles of the batteries are
in the correct position. The ± signs
on the batteries must correspond
to the ± signs in the battery
compartment.
4 Close the lid of the battery
compartment.
ba75849e06
®
6100 VIS
06/2013