Enwork Equilibrium Round Installation Instruction page 10

3) Assembly:
Fig. 4.1
4.1.1) Place top support onto base column
Fig. 4.3
4.3.1) Check that the top support is level
4.3.2) If the top support is not level, slightly
loosen the bolts and use the aluminum
shims under the top support
Installing Top Support continued
INSTALLATION GUIDE
Fig. 4.2
4.2.1) Align holes on base column with slots
on top support
4.2.2) Using 3/8"-16 x 1-1/2" flange hex bolts
and 3/8" x 1" flat washer, assemble top
support to base column
Note: Do not fully tighten hardware yet
Fig. 4.4
4.4.1) Once shims are in place, tighten the bolts
for the top support. Double check that
top support is now level.