Troubleshooting Guide - Sartorius BA 210 S Installation And Operating Instructions Manual

Troubleshooting Guide

Problem ...
No segments appear in the weight
display (12)?
The weight display shows "H"?
Weight display shows "L" or
"Err 54"?
Weight display briefly displays
"Err 02"?
The special message "
not go out in the weight display
The weight readout changes con-
stantly
The display shows "Lo Accu" or a
weight flashes in the display?
The weight readout is obviously
wrong
Causes ...
- No AC power available
- The AC adapter is not plugged in
- Sample exceeds the capacity of
the balance
- The weighing pan (1) , pan sup-
port (3) and/or compensating ring
(2) are not in place
- The CAL key (13) was not
pressed when the display indi-
cated zero
- The balance is loaded
- No key has been pressed since
" does
the balance was turned on
- Unstable ambient conditions
- Too much Vibration or the bal-
ance is exposed to a draft
- The draft shield is not completely
closed
- A foreign object is caught be-
tween the pan and the balance
housing
- The port for the below-balance
weighing attachment is
uncovered
- The sample does not have a
stable weight (absorbs moisture
or evaporates)
- The battery voltage is too low
- The balance is not calibrated
- The balance was not tared before
weighing
- The air bubble in the level indica-
tor (10) is not within the circle
Remedy
- Check AC power supply
- Plug in AC adapter
- Unload the balance
- Install weighing pan, pan support
(depends on type of model) and
compensating ring (depends on
model)
- Press the tare control
and re-press the CAL key
- Unload the balance
- Press any key
- Set up the balance in another
area
- Access the menu to adapt the
balance to the particular weigh-
ing environment
- Close the draft shield
- Remove foreign object
- Fasten the closing plate to dose
the port for below-balance weigh-
ing
- Connect balance or external
battery pack to line power using
the AC adapter
- Calibrate (see p. 19)
- Tare before weighing
- Level the balance (see p. 16 )
29