Table of Contents
Advertisement
6
SEARCHING FOR RECORDED IMAGES
ARCHIVE AREA SEARCH
Follow the procedures below to playback images from the
archive area.
1
Press the [SEARCH] button while the
digital video recorder is recording or
stopped.
The <SEARCH> screen is displayed.
2
Press the [
"ARCHIVE AREA SEARCH".
3
Press the [ ] button.
The <ARCHIVE AREA SEARCH> screen is displayed.
(1) NO: Displays the archive number.
(2) DATE: Displays the date of the recorded image.
(3) START: Displays the start time for the recorded
image.
(4) TOTAL: Displays the total capacity of the archive area.
(5) USED: Displays the amount of archive area capacity
currently filled.
4
Press the [
the image for playback.
The selected image is displayed in the preview screen.
To display the next (previous) image
Press the [
] or [
To end search mode
Press the [SEARCH] button.
5
Press the [ ] button.
The image is played back on the full screen.
English
] or [
] button to select
(1) (2) (3)
] or [
] button to select
] button.
MOTION DETECTION SEARCH
By setting images recorded in the hard disk's normal
recording area (i.e., normal recording and timer recording
images) or alarm recording area to the motion sensor,
variations from these images as a result of the presence of
an intruder or the like can be detected, and the
corresponding images can be played back.
When performing a motion detection search for a
multiplexer image, set "MULTIPLEXER" from "2. VIDEO
INPUT SET" to anything other than "NO USE". ( P. 52)
When a multiplexer capable of decoding channel
information is connected, a camera number (or
channel) can be specified, and the corresponding
camera image can be detected. This type of setting will
not be possible for any other type of multiplexer.
( P. 28)
1
Press the [SEARCH] button while the
digital video recorder is recording or
stopped.
(4) (5)
The <SEARCH> screen is displayed.
2
Press the [
"MOTION DETECTION SEARCH", then
press the [ ] button.
The <MOTION DETECTION SEARCH> screen is
displayed.
3
Press the [
"SEARCH FROM", then press the [ ]
button.
"ALARM" flashes.
[Settings] (
indicates default setting.)
Setting
Searching will only be performed for images in the
ALARM
alarm recording area.
Searching will only be performed for images in the
NORMAL
normal recording area.
ALARM &
Searching will be performed for images in the
NORMAL
alarm recording area and normal recording area.
33
] or [
] button to select
] or [
] button to select
Description
Advertisement
Table of Contents
