Removal - Sanyo DSR - 300 Instruction Manual

2 REPLACING A REMOVABLE HDD
5
Insert the tray release key, turn it in the
direction of the arrow, and then press
the [CHANGE DISK] button.
The HDD indicator will light up and the CHANGE DISK
indicator will switch from green to red.
Whenever the unit is to be transported, ensure that the
HDD tray is removed from the unit and packaged
separately.
Correct operation cannot be guaranteed with HDDs not
recorded to using a DSR-300. If you want to use a HDD
that has been recorded on by a different DVR, be sure
to initialize it before use.
Even if the tray to which the HDD has been attached is
connected directly to a PC, the playback of images will
not be possible.
If you cannot turn the tray release key when installing
the HDD tray, the HDD tray may have shifted.
Reposition the HDD tray properly.
English
1
The CHANGE DISK indicator changes from red to flashing
green, then lights steadily after 10 seconds. A buzzer
sounds intermittently in time with the indicator's flashing.
CHANGE DISK
The HDD indicator turns off.
indicator
2
This action will cause the HDD tray lock to be released.
11

Removal

With the power turned on, press and
hold the [CHANGE DISK] button for at
least 2 seconds.
[CHANGE DISK] button
When the CHANGE DISK indicator
lights in green and the HDD indicator
turns off, insert the tray release key and
turn it in the direction of the arrow.
An alarm will be sounded if the tray release key is turned
when the CHANGE DISK indicator is lit in red or before
the HDD indicator has turned off. Do not remove the HDD
tray while such an alarm is sounding. Failure to observe
this precaution can result in data being damaged.
Do not forcibly pull out the HDD tray when the tray
release key is ON as this will result in the tray being
damaged.
If you cannot turn the tray release key when installing
the HDD tray, the HDD tray may have shifted.
Reposition the HDD tray properly.
Because data might be damaged, a warning tone will
sound if the tray release key is turned without pressing
the [CHANGE DISK] button while the power is on.
If the HDD is removed without using the [CHANGE DISK]
button, there is a danger that recorded data may be lost.
The [CHANGE DISK] button is disabled during
recording or timer recording stanby.
HDD indicator
CHANGE DISK
indicator