Display Mode - Keithley 2606B System SourceMeter Reference Manual

Section 2: General operation
To turn the beeper on or off from the virtual front panel:
1. Press the MENU key, and then select BEEPER.
2. Select one of the following:

ENABLE

DISABLE
To turn the beeper on or off from the TSP command interface:
Set the beeper.enable attribute. For example, to enable the beeper, send:
beeper.enable = 1

Display mode

Use the DISPLAY key to scroll through the various display modes shown in the figure below. Refer to
Display operations
2-34
(on page 3-66) for more information about the display.
Figure 21: Display modes
2606B System SourceMeter® Instrument Reference Manual
2606B-901-01 Rev. B / May 2018