Keithley 2606B System SourceMeter Reference Manual page 442

Section 7: TSP command reference
sync_out
sourcevalues
Example
smua.reset()
smua.source.rangev = 5
smua.source.rangei = 1
smua.source.levelv = 0
smua.measure.rangev = 5
smua.measure.rangei = 1
smua.measure.nplc = 0.01
smua.measure.autozero = smua.AUTOZERO_ONCE
smua.nvbuffer1.clear()
smua.nvbuffer1.appendmode = 1
smua.source.output = smua.OUTPUT_ON
f1, msg1 = ConfigPulseVMeasureI(smua, 0, 5,
1, 0.002, 0.2, 10, smua.nvbuffer1, 1)
print(QueryPulseConfig(1).tostring())
Also see
ConfigPulseIMeasureV()
ConfigPulseIMeasureVSweepLin()
ConfigPulseIMeasureVSweepLog()
ConfigPulseVMeasureI()
ConfigPulseVMeasureISweepLin()
ConfigPulseVMeasureISweepLog()
KIPulse factory script
7-158
The sync_out digio line, if used
A table containing the source value for each point in the pulse train
(on page 7-34)
(on page 7-35)
(on page 7-38)
(on page 7-40)
(on page 7-42)
(on page 7-44)
(on page 5-18)
2606B System SourceMeter® Instrument Reference Manual
Configure channel A to generate a pulse train,
query configuration, and then display as a string.
Channel A pulses voltage from a bias level of 0 V
to a pulse level of 5 V. The pulse level is present
for 2 ms, and the bias level for 200 ms with a 1 A
limit setting. A total of 10 pulses is generated, and
the measurement data is stored in
smua.nvbuffer1. This pulse train is assigned to
tag = 1.
Output:
>> tag = 1
>> smu = smua
>> func = volts
>> type = pulse
>> bias = 0
>> level = 5
>> limit = 1
>> time on = 0.002
>> time off = 0.2
>> points = 10
>> measure = yes
>> sync_in = 0
>> sync_out = 0
>> sync_in_timeout = 0
>> sync_out_abort = 0
>> { 5, 5, 5, 5, 5, 5, 5, 5, 5, 5 }
2606B-901-01 Rev. B / May 2018