Trigger.timer[N].Passthrough - Keithley 2606B System SourceMeter Reference Manual

2606B System SourceMeter® Instrument Reference Manual
This is an indication of the state of the event detector built into the timer itself. It does not indicate if
an overrun occurred in any other part of the trigger model or in any other construct that is monitoring
the delay completion event. It also is not an indication of a delay overrun.
Delay overrun indications are provided in the status model.
Example
print(trigger.timer[1].overrun)
Also see
trigger.timer[N].reset()

trigger.timer[N].passthrough

This attribute enables or disables the timer trigger pass-through mode.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
passthrough = trigger.timer[N].passthrough
trigger.timer[N].passthrough = passthrough
passthrough
N
Details
When pass-through mode is enabled, triggers are passed through immediately and initiate the delay.
When disabled, a trigger only initiates a delay.
Example
trigger.timer[1].passthrough = true
Also see
trigger.timer[N].reset()
2606B-901-01 Rev. B / May 2018
(on page 7-352)
Affected by
Instrument reset
Recall setup
Trigger timer N reset
The state of pass-through mode; set to one of the following values:

true: Enabled

false: Disabled
Trigger timer number (1 to 8)
(on page 7-352)
Section 7: TSP command reference
If an event was ignored, the output
is true.
If the event was not ignored, the
output is false.
Where saved Default value
Not saved false (disabled)
Enables pass-through mode on trigger timer 1.
7-351