Setting The Time; Setting The Dayliight Saving Time (Dst) Switch - iHome iBTW23 Manual

S E T T I N G T H E T I M E
Press and hold the Clock Button on the top of the unit. A beep will sound
1.
and the TIME will flash on the display.
Press the + or – Buttons to set the correct time (hold for rapid
adjustment). Make sure to set the correct AM or PM time. (The PM
indicator appears to the left of the time display; there is no AM indicator.)
NOTE: The display can be set to standard 12 hour time (AM and PM) or to
24 hour time. To toggle between 12 and 24 modes, press and release the
Alarm 1 or
during time setting mode.
2. Press and release the Clock Button to confirm the current time setting.
The YEAR will flash on the display. Press the + or – Buttons to set the
correct year.
3. Press and release the Clock Button to confirm the current year setting.
The DATE will flash on the display. Press the + or – Buttons to set the
correct month and day (hold for rapid adjustment).
4. Press and release the Clock Button to confirm the current date setting.
Two beeps will sound to indicate time setting mode is complete.
SETTING THE DAYLIGHT SAVING TIME (DST) SWITCH
This unit has a DST switch on the bottom of the unit in the battery
compartment to adjust the time for daylight saving time and standard time.
By default, it is set to Auto and will automatically adjust the time at the start
and end of daylight saving time. If you are located in an area that does not
observe daylight saving time or otherwise wish to adjust manually, slide the
switch to +1 to add one hour or to –1 to subtract an hour.
Alarm 2 Button at any time while display is flashing
5