Ups Management Drop-Down Menu; Setttings Drop-Down Menu; Emd Drop-Down Menu; Username} Drop-Down Menu - Toshiba RemotEye 4 User Manual


Output Parameter: Output Voltage/Current/Frequency/Power/etc.

Bypass Parameter: Output Voltage/Current/Frequency/Power/etc.

DC Bus Parameter: DC Bus Positive/Negative/Rated Voltage.

Battery Parameter: Battery Voltage/Current/Charging Current/detection levels/etc.

UPS Home Group: Displays the Name/IP Address/UPS Mode of all RemotEye devices in the same
network.

Protected Clients: Displays the Name/IP Address/Shutdown Delay of the current protected
computers/servers.

Alert Center: Date/Event

History Logs: Individual logs for System/Inverter/Backup Operations as well as Total number of
Overloads/Backups/Faults/etc.
5.3.2

UPS MANAGEMENT Drop-down Menu

Ref. Figure 5-14 Drop-Down Menus
This is a comprehensive of all UPS MANAGEMENT options. Note: Not all options apply to all models of UPS's.

UPS Configuration General: Set Password/System Name/Rated in-Out Voltage/Battery Data

UPS Configuration Display: Set Sleep Timer and Buzzer Status.

UPS Control: Adjust output voltage, enable RMTI-4 Control, Configure Startup/Restart/Transfer delay

Battery Test: Start/Elapsed Time, set Test Schedule, Test Results

UPS Shutdown Events: Shutdown Events, Shutdown Action, Shutdown Delay

Non/Recurring On/Off: UPS Shutdown Scheduler.
5.3.3

SETTTINGS Drop-down Menu

These settings can be accessed from the SETTINGS menu (Ref. Figure 5-14 Drop-Down Menus):
(This is a comprehensive of all SETTINGS options. Note: Not all options apply to all models of UPS's.)

SNMP Settings: Configure RemotEye 4 to work with SNMP.

Modbus Settings: Configure RemotEye 4 to work with Modbus TCP or RTU.

BACnet Settings: Configure RemotEye 4 to work with BACnet IP or MSTP.

Email Settings: Enter email's to receive warnings/ notifications

RADIUS Settings: Configure RemotEye 4 to work with the RADIUS server.

Interface Settings: Configure RemotEye 4 to work with either the RS-232 or RS-485 serial port. Used for
either BACnet MSTP or Modbus RTU.

Configuration Capture Tool: Record snapshot of current configuration. Used to configure other
RemotEye 4s.

Wireless: Configure RemotEye 4 to work with wireless features.

Reminders: Set reminders

RemotEye 4 System Settings: Edit RemotEye 4 configuration settings that were entered during initial
setup.
5.3.4

EMD Drop-down Menu

Ref. Figure 5-14 Drop-Down Menus

EMD Configuration: Set the parameters and limits for the optional EMD device.
5.3.5

{Username} Drop-down Menu

Ref. Figure 5-14 Drop-Down Menus

Edit Dashboard: Enables rearranging/replacing some of the widgets on the Dashboard.

Logout: Exit the ADMIN mode.
46
RemotEye 4 User Manual – 90988-007