Brocade Communications Systems FastIron GS Hardware Installation Manual page 61

FIGURE 41
9. Slide the new DIMM into the holder at an angle (refer to the illustration) and push the
10. Push straight down on the DIMM to lock it into place in the holder.
FIGURE 42
11. If you are also installing a CX4 10GB module, proceed to
12. Remove the cover plate from the module slot on the front panel, as shown in
Brocade FastIron GS and FastIron GS-STK Hardware Installation Guide
53-1001783-01
DRAFT: BROCADE CONFIDENTIAL
FGS memory DIMM
connector end into the holder until it snaps into place.
Replacing the memory DIMM
Side view
installing a CX4 module, proceed to
1. Push memory socket tabs away from DIMM
2. Pull old DIMM up and out of holder at an angle
(see side view)
3. Slide new DIMM gently into holder at an angle
until you feel the connector end snap into place
4. Press DIMM into holder until it is flat and the tabs
on each side click into place
step 12
step 14.
Upgrading hardware
and step 13. If you are not
Figure 43.
4
51