Brocade Communications Systems FastIron GS Hardware Installation Manual page 22

1
Hardware features
FIGURE 14
LEDs for network interfaces and power supplies
The fiber and copper ports on FGS devices provide status information through the LEDs listed in
Table
•
•
•
•
•
•
TABLE 4
LED
10/100/1000 Copper Port LEDs
Lnk or Act
100/1000 Fiber Port LEDs
12
DRAFT: BROCADE CONFIDENTIAL
CX4 Transceiver Cable
4.
The 10/100/1000 copper ports (1 – 24 or 1 – 48) use the LEDs located on the top left and top
right of the upper copper connectors. These are combined Link or Activity (Lnk or Act) LEDs.
The LED on the left side is for the upper copper connector. The LED on the right side is for the
lower copper connector.
The 100/1000 fiber ports (1F – 4F) use the LEDs located beneath the fiber connectors. These
are combined Link or Activity (Lnk or Act) LEDs.
The POE ports (1 – 24) use the round LEDs located beneath the copper ports. The first
(left-most) LED is for port 1, the second LED is for port 2, the third LED is for port 3, and so
forth.
The 10 Gbps fiber ports use the LEDs located beside them.
FGS-STK devices use the Stack LEDs (1 – 8) located to the right of the console port.
Power supplies use the Pwr, PS1, and PS2 LEDs on the left side of the front panel, under the
console port.
LEDs
Position
Located along the top
of the copper ports
Left for upper copper
connector
Right for lower copper
connector
State Meaning
On The link is up.
Off The link is down.
Blinking The port is transmitting or receiving traffic
Brocade FastIron GS and FastIron GS-STK Hardware Installation Guide
53-1001783-01