Brocade Communications Systems FastIron GS Hardware Installation Manual page 42

2
Installing the device
FIGURE 28
3. Mount the device in the rack as illustrated in
NOTE
Although
device with long mounting brackets is the same.
FIGURE 29
NOTE
If you are installing a device with two power supplies into a Telco rack, you must remove one of the
power supplies in order to slide the device into the rack. The back panels of the power supplies
overhang the device by approximately .25 inches, making it impossible to insert into a standard
Telco rack with both power supplies installed.
4. Proceed to
32
DRAFT: BROCADE CONFIDENTIAL
Attaching the Long Mounting Brackets
Figure 29 shows a device with short mounting brackets, the procedure for securing a
Installing the Device in a Rack
"Powering on the system"
Figure 29.
on page 35.
Brocade FastIron GS and FastIron GS-STK Hardware Installation Guide
53-1001783-01