progressive automations flt-02 User Manual page 6

Assembly Instructions
STEP 6
Depending on your desktop, it may or may not be pre-
drilled. Make sure to check both sides of the desktop
before placing the assembled unit on the underside of
your desktop.
Adjust the width of the unit to fit your desktop by
sliding the two halves apart. We recommend to leave
at least a half inch of the desktop extending beyond
the assembled frame. Make sure to center the Side
Brackets (5a,5b).
STEP 7
If your desktop is pre-drilled skip ahead to Step 8. If
your desktop is not pre-drilled, lock the position of
the Center Rails using eight of the M6x10 Machine
Screws (10).
Make sure the screws contact the Center Rails (4)
by sliding them as needed.
STEP 8
Make sure that the wood screws are not too long for your
desktop, otherwise they will puncture the surface once
screwed all the way in.
We recommend that you pre-drill any holes needed for
fasteners if your desktop is not pre-drilled already. Do not
use countersunk screws.
Make sure the assembled unit is positioned properly on
the underside of your desktop. Attach the unit to the
underside of your desktop using seven of the M5x20
Wood Screws (13).
Attach the Hand Remote (7) so the front of the remote is
lined up with the desktop edge. Place the remote
anywhere along the edge so that you'll have easy access
to it. Use two of the M5x16 Wood Screws (14) to attach
and secure the remote to the desktop.
Make sure you do not over-tighten the screws. Doing so
could cause damage to the components.
6