7.3 LUBRICATING THE GUIDE BARS OF THE CARRIAGE AND OVERPLATE
-
After each cleaning operation of the machine put a
few drops of oil in the hole (1) of the plate (2);
-
Put a few drops of oil along the sliding bar (3) of the
carriage;
-
Turn the flywheel briefly.
Note: Only use white Vaseline oil. Do not use vegetable
oils.
7.4 ADJUSTING THE CHAIN
If you should hear a ticking noise when using the machine
check the tension of the blade chain as follows:
-
Loosen the two nuts (1) which hold the head (2);
-
Raise the head (2) until the required tension of the
chain is obtained;
-
- Tighten the nuts and check.
Installation, use and maintenance 330M
16
16