Table of Contents
Advertisement
ment, remove the corresponding control panel. If latch is
mounted on the left side, remove left side panel.
3.
Tighten both nuts down until the springs are fully com-
pressed.
4.
Back each nut off 1/2 turn.
5.
Remount the control panel or left side panel.
6.8.3 DOOR HANDLE TENSION ADJUSTMENT
The cooking compartment door handle tension is preset at the
factory and should not need adjusting unless the doors are re-
vered. Should the door handle need adjusting the procedure is
as follows:
1.
Open the cooking compartment door.
ITEM
FIGURE 6.8 DOOR LATCH AND MAGNET SENSOR ASSEMBLY
NO.
DESCRIPTION
1
DOOR LATCH
2
DOOR SENSOR (MAGNETIC REED SWITCH)
3
DOOR SENSOR MOUNTING BRACKET
4
DOOR SENSOR SPACER (6-32 HEX. NUT, zINC PLATED)
5
SPRING
6
WASHER, NYLON
7
4-40 HEX. NUT, WITH NYLON INSERT, zINC PLATED
8
4-40 SLOTTED PAN HEAD MACHINE SCREW, zINC PLATED, 3/8" LONG
9
6-32 HEX. NUT, WITH NYLON INSERT, zINC PLATED
10
6-32 SLOTTED PAN HEAD MACHINE SCREW, zINC PLATED, 1/2" LONG
11
10-32 NUT, WITH NYLON INSERT, zINC PLATED
6. MAINTENANCE
FIGURE 6.8 DOOR LATCH AND mAGNET SENSOR ASSEmBLY
2.
Remove the 6 screws, 3 from top edge and 3 from bottom
edge of door.
3.
Remove the door gasket, door gasket mounting plate and
door insert from the door. Do not disassemble these three
components, remove them as an assembly.
4.
Tighten both nuts down until the springs are fully com-
pressed.
5.
Back each nut off 5 turns.
6.
Replace the door gasket, mounting plate and insert as-
sembly.
7.
Remount the large side panel.
6.11
PART
qTY.
NO.
1
E91-5746
1
E08-6308
1
E91-5697
2
E10-2331
2
E08-4600
4
E10-0100
2
E08-3845
2
E08-3496
2
E08-3838
2
E08-3484
2
E08-3841
Advertisement
Table of Contents
