Market Forge Industries STEAM-TECH PLUS STP-6E Owner's Manual page 6

left door latch mounting holes.
11. To adjust the tension of the door latch tighten both nuts
down until the springs are fully compresses then back
each nut off 1/2 turn.
12. Replace large side panel by placing the panel against the
side of the unit. Be sure that the top edge of the side panel
slides under the top cap of the unit. Slide the panel upwards
until it stops. Then, while pushing the panel in towards the
unit slide it down into position. Replace screw.
13. Rotate the door 180 for mounting.
O
2. INSTALLATION
14.
15.
16.
2.3
Slide the remaining (small) hinge into the top door bear-
ing.
Slide the door and hinge assembly down onto the hinge
which you have already mounted to the front of the unit.
Use the two 5/16" bolts to mount the top hinge into the
right upper hinge mounting holes. DO NOT COMPLETELY
TIGHTEN THE HINGE MOUNTING BOLTS YET. These
are used later for door adjustment.
Door adjustment is covered in section 6.8 on page 6.9.