Table of Contents
Advertisement
6. Maintenance
6.6.2
Door Latch Tension Adjustment
Caution: Shut off main electrical power to unit.
P
ROCEDURE
1. Open the cooking compartment door.
2. Remove the control panel as described in section 6.5.
3. Tighten both nuts on the back of the latch until the
springs are fully compressed.
1
4. Back each nut off 1
/
2
5. Remount the control panel.
6.6.3 Door Handle Tension Adjustment
P
ROCEDURE
1. Open the cooking compartment door.
2. Remove the 6 screws and washers from the top edge and
from the bottom edge of the door.
3. Remove the inner door gasket mounting plate assembly
from the outer door. Do not disassemble these three com-
ponents—remove them as an assembly.
4. Tighten both nuts on the back of the handle until the
springs are fully compressed.
1
5. Back each nut off 1
/
2
6. Remount the inner door gasket mounting plate assembly
by assembling the 6 screws and washers.
(continued)
turn.
turn.
6.7
Door Gasket Replacement
The cooking compartment door gaskets are made of a silicone
type rubber material, which is very durable but subject to
wear during normal operation. Should the gasket leak, read-
just the door gasket to the unit or replace it.
P
: R
ROCEDURE
EPLACE
1. Open the cooking compartment door.
2. Remove the (3) screws from the top of the door, and the
(3) screws from the bottom of the door.
3. Remove the inner door, gasket plate and gasket.
4. Remove the (6) nuts on the back of the inner door.
5. Remove the door gasket mounting plate and the door
gasket.
6. Install the new door gasket (REF. Table 7.3 for part num-
ber) to the mounting plate.
7. Reassemble the mounting plate with gasket to the inner
door using the (6) nuts.
NOTE: Remember that the lip on the door gasket
mounting plate must fit into the channel on the inside
edge of the gasket to insure a proper seal.
8. Reassemble the inner door, mounting plate, and gasket
with the outer door using the (3) screws on the top and
bottom of the dooor.
P
: T
A
ROCEDURE
O
DJUST
To prevent steam leaks around the door, adjust the gasket
tension to cavity. Adjust the gasket by loosening the 6 screws
on top and bottom of door, move inner door plate in or out,
left side or right side, and tighten the 6 screws.
6-3
G
ASKET
G
U
ASKET TO
NIT
Advertisement
Table of Contents
