Adjustments - Vinten PRO-5Plus Operator's Manual

Adjustments

Pan brake knob adjustment
Because its movement is restricted, the pan brake knob
longed use.
To adjust the pan brake knob
Remove the securing screw
Turn the shaft (10.2)
Install the knob (10)
the body of the head.
Turn the knob fully counterclockwise and ensure the brake is released. Turn the knob clock-
wise and ensure the brake is applied before the knob reaches the end of its travel.
Readjust as necessary and secure the knob with the screw (10.1).
Tilt brake knob adjustment
The tilt drag knob (13)
To adjust the tilt brake knob
Remove the securing screw
Turn the shaft (13.2)
Install the knob (13)
position, pointing toward the rear of the head.
Turn the knob counterclockwise by half a turn and ensure the brake is released. Turn the
knob clockwise and ensure the brake is applied before the knob reaches the end of its travel
or interferes with other head controls.
Readjust as necessary and secure the knob with the screw (13.1).
(Fig. 7):
(10.1) and pull the knob
clockwise until the pan brake is fully applied.
on the shaft (10.2)
may also require adjustment after prolonged use:
(Fig. 7):
(13.1) and pull the knob
clockwise until the pan brake is fully applied.
on the shaft (13.2) with the lever approximately horizontal in a 3 o'clock
(10) may require adjustment after pro-
(10) off the shaft (10.2).
positioned just beyond right angles (clockwise) to
(13) off the shaft (13.2).
Back
21