Completion Procedures - Harmar Mobility IL500 Sierra Inclined Platform Lift Installation & Service Manual

TEST CONTROL SWITCH
1.
Ensure that the unit travels correctly by
operating the control switch while standing
in front of the unit.
2.
Depress the switch in the upstairs
direction to move up. The lift will beep. Wait
three (3) seconds and begin to smoothly
accelerate upwards. The lift will continue
to move upwards as long as the switch is
depressed.
3. Release the switch and the lift will come to
an immediate stop.
4.
Depress the switch in the downstairs
direction to move down. The lift will beep,
wait three (3) seconds and begin to smoothly
accelerate downwards.
5.
Release the switch and the lift will come to
an immediate stop.
6.
Run the lift all the way up and down the
rail to ensure there is at least a 1/2" clearance
from the wall and any obstructions.
DO NOT ride on the lift until the install
is complete.
WARNING
TEC0029 2016SEPT12 PN: 630-00001 REV C
TIGHTEN BRACKETS
1.
Install and fully tighten the rail bracket
mounting screws, four (4) screws per
bracket. For hardwood stairs, drill a pilot
hole first. For plywood or particle board
stairs, take care to prevent stripping.
SET UPPER AND LOWER TRAVEL
LIMITS
1.
Test the lower travel limit by operating
the lift downward, keeping the switch
depressed. The lift should begin to
decelerate about 3" from its final resting
position and stop clear of the floor.
2.
The final stopped position can be
adjusted to accommodate the height of the
ramp to the floor by repositioning the limit
cam located in a slot in the rail.
3.
Use a 5/64" Allen wrench to loosen the set
screw in the limit cam. Adjust the limit cam
up or down and retighten the set screws.
Repeat the above steps until the lift stops in
the desired position.
YOUR LIFT IS NOW
READY TO OPERATE.
IL500 Sierra Inclined Platform Lift - Installation & Service Manual

Completion Procedures

15