Harmar Mobility IL500 Sierra Inclined Platform Lift Installation & Service Manual page 9

16. If equipped with a 90° ramp,
through the gray slide block on the underside of the ramp
and attach the ramp to the hinge with three (3) Phillips head
screws and nuts.
[Figure 9-1]
17. Insert the upper limit cam into the slot in the rail
the top and tighten the set screw, this will need to be adjusted
later to stop the lift in the proper location.
Insert the rest of the gear rack into the top of the rail. The gear
rack should be even with the end of the rail and the last piece
may need to be cut off. Install the end plate using the four
Torx head screws and Torx driver (provided).
18. Install the rack compression screw
to pre-load the gear rack. Install the Hand Rail end plates into
each end of the Hand Rail.
TEC0029 2016SEPT12 PN: 630-00001 REV C
insert the corner rod
[Figure 9-2]
into the end plate
[Figure 9-3]
IL500 Sierra Inclined Platform Lift - Installation & Service Manual
Installation Procedures
at
Figure 9-1
Figure 9-2
Figure 9-3
9