Smbus Connector; Standby Power Led - DFI BW171 User Manual

SMBus Connector

1 2
GND
3V3SB
SMBUS Clock SMBus_Data
SMBUS_Alert
5 6
The SMBus (System Management Bus) connector is used to connect SMBus devices. It is a
multiple device bus that allows multiple chips to connect to the same bus and enable each one
to act as a master by initiating data transfer.
Chapter 2 Hardware Installation
Chapter 2

Standby Power LED

1
This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
27
1
Standby Power LED
www.dfi.com