Rear Panel I/O Ports; Dc-In (Bw171)/15~36V (Bw173) - DFI BW171 User Manual

Rear Panel I/O Ports

DC-in
VGA
DP
The rear panel I/O ports consist of the following:
• 2 GbE (RJ-45)
• 2 USB 3.0
• 2 USB 2.0
• 1 VGA
• 1 DP++
• 1 Line-out
• 1 DC-in
Chapter 2 Hardware Installation
USB 3.0 USB 2.0
LAN 2
LAN 1
Line-out
Chapter 2
12V DC-in (BW171)/15~36V (BW173)
DC-in
This jack is considered a low power solution. Connect a DC power cord to this jack. Using a
voltage more than the recommended range may fail to boot the system or cause damage to
the system board.
The DC-in jack on the system board co-lays with a 4-pin right angle connector (optional) or
4-pin vertical type connector (optional) as the photo displayed below.
4-pin Right Angle
(optional)
18
1
4-pin Vertical Type (optional)
DC-in (default)
www.dfi.com