4. Operating the Insert
Before using the insert, the following steps should be followed:
• Install the faceplate (See
«Appendix 1. Faceplate
Installation»)
• Plug in the blower power cord. The sleeve (A) and the power cord (B) can be found in the owner's
manual kit. Refer to the following figure.
B
A
1
2
3
Figure 7: Plugging in the blower power cord
The following steps are optional :
• Install the fresh air intake (See
«Appendix 2. Optional Fresh Air Intake Kit
Installation»)
• Install the refractory slabs (See
«Appendix 5. Optional Refractory Panels
Installation»)
4.1
Cold Hand
The cold hand is a handle, supplied with the insert. It allows to open the door and avoid burns.
To open, insert the cold hand into the opening on the right side of the insert. Pull on the cold
hand to open the door. Push to close the door. The cold hand should not remain on the insert
when it is in use and should be kept outside the heat radiation zone of the appliance.
Figure 8: Opening on the right side of the insert
Figure 9: Pull on the cold hand to open the door.
Installation and Operation Manual - Inspire 2000 Insert
Page 15