Operating The Insert - Osburn 1700-I Installation And Operation Manual

4. Operating the Insert

This wood heater has a manufacturer-set minimum low burn rate that must not be
altered. It is against federal regulations to alter this setting or otherwise operate this
wood heater in a manner inconsistent with operating instructions in this manual.
Before using the insert, the following steps should be completed :
• Empty the combustion chamber and install the air control handle (A) with the set screw (B) as
shown below:
A
B
Figure 8: Empty the combustion chamber Figure 9: Installing the air control wood handle
• Install the combustion chamber side bricks as shown below.
Figure 10: Install the Combustion Chamber Bricks Figure 11: Combustion Chamber Bricks Layout
• Install the ash lip and the blower (see «Appendix 1: Blower and Ash Lip Installation»);
• Install the door overlay (see «Appendix 2: Door Overlay Installation»);
• Install the faceplate (See «Appendix 4: Faceplate And Trims Installation»).
The following step is optional :
• Install the fresh air intake (See «Appendix 3: Optional Fresh Air Intake Kit Installation»).
Page 16
Installation and Operation Manual - Osburn 1700-I