Table of Contents
Advertisement
4.2
Blower Operation
Figure 10: Blower location
Allow the insert to reach operating temperature
(approximately one hour) before turning on
the blower, since increased airflow from the
blower will remove heat and affect the start up
combustion efficiency.
The blower is equipped with a heat sensor.
Therefore, the switch can be left in the automatic
position (A). The blower will start automatically
when the insert is hot enough and it will stop
when the insert has cooled down. The switch
can also be set to the manual position (M) to
turn on the blower manually and have it run
continuously. The position (O) stops the blower
and prevents it from starting automatically
when the insert is hot enough.
Page 16
A blower is already installed on this insert. It is
located behind the bottom louver of the insert.
Its function is to increase airflow through the
heat exchanger and improve hot air circulation
in the room. When used regularly, the blower
can provide a small increase in efficiency, up
to 2%. However, it should not be used as a
way to gain more output from an insert that
is undersized for the space it is intended to
heat.
Ensure the blower cord is not in
contact with any surface of the
insert to prevent electrical shock
or fire damage. Do not run cord
underneath the insert.
Figure 11: Blower modes
Installation and Operation Manual - Inspire 2000 Insert
Hide quick links:
Advertisement
Table of Contents
