Welch Allyn CP 100 Update To Directions For Use page 30

48 Chapter 5 Performing ECG Tests
Recording a Stat Auto ECG
A stat Auto ECG is an immediate printout.
Stat mode bypasses patient data entry, as shown in
Use. A temporary ID number is assigned to the patient to identify stat tests.
To Record a Stat Auto ECG
1. Press and hold the Auto ECG key
The electrocardiograph begins acquiring ECG data. After it has acquired 10 seconds of
quality data, it prints a report.
Note
2. Go to
WARNING To avoid the risk of associating ECG reports with the wrong patients,
each report must identify the patient. If any ECG report does not identify the
patient, write the patient identification information on the report immediately
following the ECG test.
Write the patient identification information on the printed report immediately after
the ECG test to avoid associating the ECG report with the wrong patient.
ECG report Print Copy feature will not be available if no Patient Name or ID are
entered.
Step 4 on page 50.
Welch Allyn CP 100 Electrocardiograph
Figure 31 on page 48 in Directions for
.