Schwinn IC2 Service Manual page 59

19. Installation is the reverse procedure.
NOTICE: Install the Flywheel Retainer Clips (A) at the position
that you recorded in step 14. Make sure the Flywheel
(G) can turn easily.
NOTICE: Do not crimp any cables.
Note: Before closing the Chain Guard Door (3), verify that the
Speed Sensor (S4) and Speed Sensor Magnet (S5) on
the Sprocket Drive (K) do not touch.
20. Make sure that the Drive Chain tension is correct. Refer to the
"Adjust the Chain Tension" procedure.
21. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
59