Schwinn IC2 Service Manual page 21

Disconnect the data cable from the console before you service this machine.
Note: Your machine may not match the image. For reference only.
1. Loosen and remove the old Pedals.
Discard the old Pedals.
Note: The Left Pedal is reverse-threaded.
Orientation is based from a seated position
on the bike. The Left Pedal has an "L",
the Right Pedal an "R".
2. Install the new Pedals. Carefully align the threads and hand
tighten to prevent crossthreading. Then tighten fully
with pedal wrench.
Note: The Left Pedal is reverse-threaded. Be sure
to attach Pedals on the correct side of
the Bike. Orientation is based from a
seated position on the bike. The Left Pedal
has an "L", the Right Pedal an "R".
3. Final Inspection
Inspect your machine to ensure that all hardware is
tight and components are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the
Owner's Manual.
L
L
21
R
R