Schwinn IC2 Service Manual page 12

Disconnect the data cable from the console before you service this machine.
Note: Your machine may not match the image. For reference only.
1. Using a #2 Phillips screwdriver, loosen and remove the hardware
that attaches the Brake Cover to the Main Frame. Set the Brake
cover and hardware safely aside for reassembly.
NOTICE: Hold the Brake Cover so that it does not fall.
2. Loosen the Resistance Knob (A) to the minimum resistance
setting.
3. Loosen and remove the hardware that attaches the Brake Pad
(B) to the Brake Assembly (C).
4. Slide the Brake Pad (B) out of the Brake Assembly (C).
B
C
12
A