Schwinn IC2 Service Manual page 34

3. Using a wrench and socket, remove the Hex Head Bolt (C)
under the threaded Cap (B).
4. Thread the Crank Puller into the Crank Arm (A). When the
Crank Puller is in the correct position, only 1-2 threads on the outer
portion (CP2) of the Crank Puller should show.
Note: Be sure the end of the Bolt (CP1) of the Crank Puller is
flush with the Nut (CP2) as shown, before use.
5. Using a wrench, turn the inner portion (CP3) of the Crank
Puller clockwise. The Crank Arm (A) will slide off as it is tightened.
Discard the old parts.
6. Installation is the reverse procedure.
7. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
A
C
CP1 CP2
34
CP3